Configuring DMX input and output with an Enttec Pro Mk2

This forum is for general discussion on VenueMagic. If you have something off-topic please use the off-topic board.
Post Reply
draponi
Posts: 2
Joined: Mon Oct 05, 2015 5:06 pm

Configuring DMX input and output with an Enttec Pro Mk2

Post by draponi »

I'm using DMX+AV 3.0.21. I can assign the input, but if I do, no outputs are shown as assignable. Un-assigning the input displays two outputs available. After assigning output 2, the input cannot be assigned. The Pro Mk2 has independent input and output, so I'm not sure what the problem is here. Any ideas?

Post Reply